Removal Procedure
- Remove the right side insulator panel. Refer to Insulator Panel
Replacement in Instrument Panel, Gauges and Console.
- Disconnect the electrical connector (3) from the stoplamp switch (4).
- Remove the stoplamp switch (4) from the bracket (1)
by grasping the stoplamp switch and turning it 90 degrees counter clockwise
while pulling toward the rear of the vehicle.
Installation Procedure
- Install the stoplamp switch (4) in the bracket (1) until
the stoplamp switch (4) is seated on the bracket (1).
- Connect the electrical connector (3) to the stoplamp switch (4).
- Adjust the stoplamp switch. Refer to Stoplamp Switch Adjustment.
- Install the right side insulator panel. Refer to Insulator Panel
Replacement in Instrument Panel, Gauges and Console.