Removal Procedure
- Raise and support the vehicle on a suitable
hoist. Refer to Lifting and Jacking the Vehicle in General Information.
- Disconnect the front wheel speed sensor electrical connector.
- Remove the retaining bolt.
Important: If the sensor locating pin breaks off and remains in the knuckle during
removal, proceed as follows:
- Remove the brake rotor and remove the broken pin using a blunt
punch.
- Clean the hole using sand paper wrapped around a screwdriver or
other suitable tool. Never attempt to enlarge the hole.
- Remove the front wheel speed sensor. If the sensor will not slide out
of the knuckle, remove the brake rotor and use a blunt punch or equivalent
tool in order to push the sensor from the back side of the knuckle.
Installation Procedure
- Install the front wheel speed sensor
to the steering knuckle.
- Install the retaining bolt.
Tighten
Tighten the retaining bolt to 12 N·m (107 lb in).
- Connect the front wheel speed sensor electrical connector.
- Lower the vehicle.
- Perform the ABS Diagnostic System Check.