GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Optra 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Ignition and Start Switch Replacement

Removal Procedure

    Object Number: 1308230 Size: SH
  1. Remove the ignition switch lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  2. Remove the ignition switch retaining screw.
  3. Disconnect the wiring and remove the ignition switch.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1308230 Size: SH
  1. Install the ignition switch with the ignition switch retaining screw.

    2. Tighten
    Tighten the ignition switch retaining screw to 2.5 N·m (22 lb in).

  2. Connect the wiring to the ignition switch.
  3. Install the ignition switch lock cylinder. Refer to Ignition Lock Cylinder Replacement .