GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Monte Carlo 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Front Side Door Lock Replacement

Front Side Door Lock Replacement Impala


Object Number: 1650507 Size: SF

Callout

Component Name

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the interior trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
  3. Remove the outside door handle. Refer to Front Side Door Outside Handle Replacement .

1

Screw, Front Side Door Lock (Qty: 3)

Tighten
10 N·m (89 lb in)

2

Lock Assembly, Front Side Door

Tip

  1. Release the door lock cable retainers from the door.
  2. Disconnect the door lock electrical connector.
  3. Remove the door lock with the handle housing.
  4. Remove the handle and lock rods from the lock.

Front Side Door Lock Replacement Monte Carlo

Removal Procedure

    Object Number: 308342 Size: MH
  1. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement.
  2. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement.
  3. Remove the front door inside handle rods from the front door inside handle.
  4. Remove the clip securing the front door inside handle rods to the front door.
  5. Remove the outside handle rod-to-lock clip from the lock .

    6. Object Number: 308343 Size: SH
  6. Remove the screws (1) securing the lock to the front door.
  7. Remove the lock from the front door with the inside handle rods attached to the lock.
  8. Disconnect the electrical connectors.
  9. Remove the front door inside handle rods from the lock.

Installation Procedure

    Object Number: 308342 Size: MH
  1. Install the front door inside handle rods to the lock.
  2. Install the front door lock in the position through the access hole in the front door inner panel.
  3. Connect the electrical connectors.

    4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 308343 Size: SH
  4. Install the front door lock screws in the proper fastener tightening sequence: top (1), bottom (2), middle (3).

    5. Tighten
    Tighten the front door lock screws to 10 N·m (89 lb in).


    Object Number: 308344 Size: SH
  5. Install a NEW outside handle rod-to-lock clip onto the front door lock lever.
    6. 5.1. Position the front door outside door handle rod in the clip to eliminate any free play in the front door outside door handle.
    5.2. Install the clip cover closed over the threaded front door outside door handle rod.
  6. Install the clip to the front door inside handle rods.
  7. Install the front door handle rods to the handle.
  8. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement.
  9. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement.
  10. Inspect the door lock system for the proper operation.