GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 24319-B Universal Steering Linkage Puller

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

  3. Object Number: 575833  Size: SH
  4. Remove the prevailing torque nut (2) from the outer tie rod assembly (1).

  5. Object Number: 297349  Size: SH
  6. Loosen the jam nut (2) on the inner tie rod assembly (1).
  7. Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.


    Object Number: 643351  Size: SH
  8. Remove the outer tie rod assembly from the steering knuckle using J 24319-B .

  9. Object Number: 297358  Size: SH
  10. Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).

Installation Procedure


    Object Number: 297355  Size: SH
  1. Install the outer tie rod assembly (3) to the inner tie rod assembly (1). Do NOT tighten the jam nut (2).

  2. Object Number: 297628  Size: SH
  3. Install the outer tie rod assembly (2) to the steering knuckle (1).
  4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 575833  Size: SH
  5. Install the prevailing torque nut (2) to the outer tie rod assembly (1).
  6. Tighten
    Tighten the nut to 30 N·m (22 lb ft) plus 120 degrees . Visually inspect to ensure that 2 ½ to 4 ½ threads are visible past the nylon washer.


    Object Number: 297355  Size: SH
  7. Install tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
  9. Perform a front end alignment. Refer to Wheel Alignment Measurement .