GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Monte Carlo 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Engine Coolant Temperature Sensor Replacement

Removal Procedure

    Object Number: 15986 Size: SH
  1. Relieve coolant pressure.
  2. Air intake duct.
  3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in engine electrical.
  4. Disconnect the ECT sensor electrical connector.
  5. Using a deep well socket and extension, remove the sensor.

Installation Procedure

    Object Number: 15986 Size: SH
  1. Coat engine coolant temperature sensor threads with sealer P/N 9985253 or equivalent.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the sensor in the engine.

    3. Tighten
    Tighten the sensor to 23 N·m (17 lb ft).

  3. Connect the ECT sensor electrical connector.
  4. Reconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in engine electrical.
  5. Start the engine.
  6. Check for leaks.
  7. Check the coolant level.