GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Malibu Classic 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Replacement

Removal Procedure

    Object Number: 1775160 Size: SH
  1. Remove the intake manifold cover. if required. Refer to Intake Manifold Cover Replacement .
  2. Remove the power steering pump, if required. Refer to Power Steering Pump Replacement .
  3. Disconnect the fuel injector wiring harness electrical connector from the camshaft position (CMP) sensor.

    4. Object Number: 1599076 Size: SH
  4. Remove the CMP sensor bolt.
  5. Remove the CMP sensor.
  6. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.

Installation Procedure

    Object Number: 1599076 Size: SH
  1. Replace the O-ring seal if damaged, lubricate the NEW O-ring with clean engine oil.
  2. Install the CMP sensor.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the CMP sensor bolt.

    4. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1775160 Size: SH
  4. Connect the fuel injector wiring harness electrical connector to the CMP sensor.
  5. Install the power steering pump, if required. Refer to Power Steering Pump Replacement .
  6. Install the intake manifold cover. if required. Refer to Intake Manifold Cover Replacement .