Notice: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

Notice: Do not use any solvent that contains Methyl Ethyl Ketone (MEK). This solvent may damage fuel system components.

1. Remove the air cleaner resonator. Refer to Air Cleaner Outlet Resonator Replacement .
2. Disconnect the engine wiring harness electrical connector from the electronic throttle control (ETC).



3. Remove the throttle body bolts.
4. Remove the throttle body from the intake manifold.

1. Inspect the throttle body gasket and replace if necessary.
2. Position the throttle body to the intake manifold.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the throttle body bolts.

Tighten
Tighten the bolts to 10 N·m (89 lb in).




4. Connect the engine wiring harness electrical connector to the ETC.
5. Install the air cleaner resonator. Refer to Air Cleaner Outlet Resonator Replacement .