| Table 1: | Starter/Generator Control Module Scan Tool Data Parameters |
| Table 2: | Starter/Generator Control Module Scan Tool Output Controls |
Parameter | System State | Expected Value | Description |
|---|---|---|---|
Operating Conditions: Ignition ON | |||
APM Control Mode | -- | Off | The scan tool displays Off, High to Low, Low to High or Not Used. This is the state of the auxiliary power module (APM) control mode. |
APM Control Status | -- | Charging | The scan tool displays Charging, Current Limited, Shutdown or Not Used. This is the auxiliary power module (APM) control status. |
Desired APM Voltage | -- | Varies | This displays Volts. This is the desired auxiliary power module (APM) voltage. |
Generator Starter Field Current | -- | Varies | This displays amps. |
Generator Starter Field Current | -- | Enable | The scan tool displays Enable or Disable. This is the current state of the generator starter field. |
Hill Hold Solenoid 1 | -- | Varies | This displays %. |
Hill Hold Solenoid 2 | -- | Varies | This displays %. |
Hill Hold Solenoid Relay | -- | Varies | This displays Enable or Disable. This is the current state of the hill hold solenoid relay. |
Hood Position | -- | Closed | The scan tool displays Open or Closed. This is the current position of the hood switch. |
Hybrid System Voltage | -- | Varies | This displays Volts. This is the current hybrid system voltage. |
SGCM 12 Volt Converter | -- | Varies | This displays amps. |
SGCM Converter Temperature | -- | Varies | This displays °C (°F). This is the current starter/generator control module (SGCM) converter temperature. |
SGCM Internal Temperature | -- | Varies | This displays °C (°F). This is the current starter/generator control module (SGCM) internal temperature. |
SGCM Inverter Temperature | -- | Varies | This displays °C (°F). This is the current starter/generator control module (SGCM) inverter temperature. |
Starter Generator Speed | -- | Varies | This displays RPM. |
Starter Generator Temperature | -- | Varies | This displays °C (°F). |
Output Control | Description |
|---|---|
Brake Hold Sol. 1 | This output control commands the brake hold solenoid 1 ON and OFF. |
Brake Hold Sol. 2 | This output control commands the brake hold solenoid 2 ON and OFF. |
SGCM Field Current | This output control commands the starter/generator control module (SGCM) field current ON and OFF. |
