1

Front Fender Emblem

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Procedure

1. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
2. Use a J 25070 Heat Gun or equivalent to remove the old emblem.
3. Clean all adhesive from the front fender and wipe the surface dry with a clean lint-free towel prior to installing the new emblem.
4. When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
5. Peel the adhesive backing from the emblem.
6. Locate and position the emblem to the front fender.
7. Using the palm of the hand, wet out the emblem to the front fender to ensure full adhesion of the emblem is made.

Special Tools

J 25070 Heat Gun - 500-750F