Warning: Refer to SIR Warning in the Preface section.

Warning: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws.

Warning: Refer to SIR Seatbelt Pretensioner Handling Warning in the Preface section.

Preliminary Procedure

1. Disable SIR. Refer to SIR Disabling and Enabling.
2. Remove the garnish molding center pillar lower. Refer to Center Pillar Lower Garnish Molding Replacement.

1

Front Seat Shoulder Belt Guide Track Cover

2

Front Seat Belt Retractor D Ring Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten
45 N·m (33 lb ft)

3

Front Seat Shoulder Belt Guide Bolt (Qty: 2)

Tighten
10 N·m (88 lb in)

4

Front Seat Shoulder Belt Guide

5

Front Seat Shoulder Belt Retractor Assembly Bolt

Tip
Disconnect electrical connector.

Tighten
45 N·m (33 lb ft)

6

Front Seat Belt Anchor Plate Bolt

Tighten
10 N·m (88 lb in)

7

Front Seat Belt Retractor Belt Assembly