Preliminary Procedure

1. Remove the instrument panel accessory upper trim panel. Refer to Instrument Panel Accessory Upper Trim Plate Replacement .
2. Remove the HVAC control module. Refer to HVAC Control Module Replacement .

1

Radio Screw (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

2

Radio Assembly

Procedure

1. Disconnect electrical connector.
2. Disconnect antenna cable.
3. When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.
4. Reprogram the radio after replacement. Refer to Control Module References .