Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.

Caution: Refer to SIR Caution in the Preface section.

Important: The steering wheel module uses stiffer springs to secure the module to the steering wheel which requires more effort to remove then the previous model. The technician should release the driver airbag module from one side only, not both sides at the same time.

1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling.
2. Insert a 4 mm T handle Alien wrench, or equivalent tool with a blunt end through the access opening on either side of the steering wheel (1).

Insert the tool approximately 48 mm to contact the spring (2).




3. Once contact has been made with the spring, push the spring fastener inward approximately 5 mm to clear the steering wheel module (1) spring from the steering wheel retainer.



4. While keeping inboard pressure on the spring, with moderate pressure pull sharply on the steering wheel module (1) until disengaging the module (1) completely from the steering wheel.
5. Disconnect the electrical connectors.

1. Connect the electrical connectors (1).



2. Align the steering wheel module fasteners to the steering column fastener holes.
3. Push the steering wheel module (1) firmly into the steering column in order the engage the fasteners.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.
5. After replacing the module, fully deploy the old module before disposal.

If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.