Master Cylinder Reservoir Replacement Without RPO LAT

Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.

1. Disconnect the brake fluid level indicator switch electrical connector.
2. Remove and discard the brake fluid from the master cylinder reservoir.
3. Remove the master cylinder reservoir bolt (1).



4. Remove the reservoir (1) from the master cylinder.



5. Remove the reservoir seals (1) from the master cylinder.

1. Inspect the master cylinder reservoir for damage and replace, if necessary.
2. Clean the reservoir with denatured alcohol.
3. Dry the reservoir with filtered, non-lubricated compressed air.



4. Lubricate the seals and the reservoir bayonets with Delco Supreme 11®, GM P/N 12377967 (Canadian P/N 992667) or equivalent DOT-3 brake fluid.
5. Install the reservoir seals (1) to the master cylinder.



6. Install the reservoir (1) to the master cylinder.

Notice: Refer to Fastener Notice in the Preface section.




7. Install the master cylinder reservoir bolt (1).

Tighten
Tighten the bolt to 8 N·m (71 lb in).

8. Connect the brake fluid level indicator switch electrical connector.
9. Fill the master cylinder reservoir. Refer to Master Cylinder Reservoir Filling.

Master Cylinder Reservoir Replacement With RPO LAT

Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.

1. Remove the master cylinder from the vehicle. Refer to Master Cylinder Replacement .



2. Remove the fluid level sensor. Refer to Brake Fluid Level Indicator Switch Replacement .
3. Drain the brake fluid from the master cylinder reservoir.
4. Secure the mounting flange of the brake master cylinder in a bench vise so the rear of the primary piston is accessible.
5. Carefully tap out the reservoir retaining pins until clear of reservoir.



6. Remove the reservoir from the master cylinder.
7. Remove the seals from the master cylinder reservoir.

1. Inspect the reservoir for cracks or deformities. If found, replace the reservoir.
2. Clean the reservoir with clean denatured alcohol, or equivalent.
3. Dry the reservoir with non-lubricated, filtered air.



4. Lubricate the new seals and the reservoir bayonets with new Delco Supreme 11®, GM P/N 12377967 (Canadian P/N 992667) or equivalent DOT-3 brake fluid.
5. Install the seals, making sure they are fully seated.
6. Install the reservoir onto the master cylinder by pressing straight down by hand until pin holes are aligned.



7. Carefully tap in the reservoir retaining pins to secure the reservoir.
8. Fill the master cylinder reservoir. Refer to Master Cylinder Reservoir Filling .
9. Install the brake fluid level sensor. Refer to Brake Fluid Level Indicator Switch Replacement .
10. Remove the master cylinder from the vise.
11. Install the master cylinder to the vehicle. Refer to Master Cylinder Replacement .