GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Important: The communication interface module has a specific set of unique numbers that tie the module to each vehicle. These numbers, the 10-digit station identification and the 11-digit electronic serial number, are used by the National Cellular Network and OnStar to identify the specific vehicle. Because these numbers are tied to the vehicle identification number of the vehicle, you must never exchange these parts with those of another vehicle.

  1. Remove the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gages and Console.
  2. Release the Glove Box opening stop tabs to allow glove box to rotate fully open for access to fasteners.
  3. Disconnect the communication interface module wire harness and antenna connectors.

  4. Object Number: 1230581  Size: SH
  5. Remove the communication interface module bolts.

  6. Object Number: 1207697  Size: SH
  7. Remove the communication interface module.

Installation Procedure


    Object Number: 1207697  Size: SH
  1. Install the communication interface module.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Tighten the communication interface module bolts.
  4. Tighten
    Tighten the bolts to 10 N·m (89 lb in).

  5. Connect the communication interface module wire harness and antenna connectors.
  6. Install the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gages and Console.
  7. Important: After replacing the communication interface module, you must reconfigure the OnStar system. Failure to reconfigure the system will result in an additional customer visit or repair. In addition, pressing and holding the white dot button on the keypad will NOT reset the OnStar system. This action will cause a DTC to set.

  8. Reconfigure the OnStar system. Refer to Control Module References in Computer/Integrating Systems.