Tools Required

J 43244 Relay Puller Pliers

1. Remove the electrical centre cover.
2. Locate the relay. Refer to Electrical Center Identification Views to locate the electrical centre where the relay exists.

Important: 

•	Always note the orientation of the relay.

•	Ensure that the electrical centre is secure, as not to put added stress on the wires or terminals.




3. Using the J 43244  (1) position the tool on opposing corners of the relay (2).

Notice: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.

4. Remove the relay (2) from the electrical centre.