Parameter | Operating Conditions | Expected Value | Definition |
|---|---|---|---|
Ignition is ON, engine OFF, and vehicle is stationary | |||
Battery Reconnect | -- | Yes | The scan tool displays Yes or No to indicate whether a battery reconnect. This is used for substitution detection to determine if a check needs to be made for substituted parts. |
-- | No | ||
Engine Start Disable | Engine start disable activated | Yes | The scan tool displays if the engine start is disabled Yes or No. |
Engine start disable deactivated | No | ||
Ignition Voltage Status | -- | Active | The scan tool displays if ignition voltage is not present. |
Inactive | |||
Immobilisation | Immobilisation activated | Active | The scan tool displays Active or Inactive to indicate the status of the immobilisation. |
Immobilisation deactivated | Inactive | ||
Invalid Transponder Key | -- | Yes | The scan tool displays Yes if a transponder key is present. |
No | |||
Substitution Detection | -- | Passed | The scan tool displays Passed/Failed for the substitution detection system. |
-- | Failed | ||
System Power Mode | Ignition is in OFF position | Off | This parameter displays Off/Accessory/Run/Crank. This is the status of the system power mode dependent on the ignition position. |
Ignition is in ACC position | Accessory | ||
Ignition is in RUN position | Run | ||
Ignition is in CRANK position | Crank | ||
Tamper Status | -- | Active | The scan tool displays whether theft is in the tamper state. |
-- | Inactive | ||
Theft Deterrent DTC | -- | Present | The scan tool displays whether a DTC has been logged or not. |
-- | Not Present | ||
Theft Deterrent Status | -- | Lrn Keys Stdby | This is dependent on the position of the ignition key. |
-- | Wakeup | ||
-- | Monitor Key | ||
Theft Deterrent Telltail | -- | On | The scan tool displays On if the theft deterrent system has been activated. |
-- | Off | ||
Transponder Key ID Error | -- | Yes | The scan tool will display Yes if the key id does not match the theft module. |
-- | No | ||
Transponder Key Number | -- | 1 | The scan tool displays 1/2/3/4. depending what key in the ignition. |
-- | 2 | ||
-- | 3 | ||
-- | 4 | ||
Transponder Key Programmed | -- | 1/2/3/4 | The scan tool displays the number of transponder keys programmed. |
Valid Transponder Key | -- | Yes | The scan tool displays Yes if a valid transponder key is present. |
No | |||
VIN Message Received | -- | Yes | The scan tool displays whether a VIN message has been received. |
-- | No | ||
VIN Received | -- | Yes | The scan tool displays when the VIN has been received. |
-- | No | ||
VIN Valid | -- | Yes | The scan tool displays when a VIN is valid or not. |
-- | No | ||
Wrong Transponder Key | -- | Yes | The scan tool displays if the transponder key is correct or incorrect. |
-- | No | ||
