GM Service Manual Online
For 1990-2009 cars only

Tools Required

    • J 5403 Snap Ring Pliers
    • J 9553-01 O-Ring Remover
    • J 39400-A Halogen Leak Detector

Removal Procedure


    Object Number: 573960  Size: SH
  1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging .
  2. Clean the control A/C high pressure switch area before removing the snap ring.
  3. Disconnect the electrical connector from the A/C high pressure switch (2).
  4. Remove the A/C high pressure switch snap ring using theJ 5403 .
  5. Remove the A/C high pressure switch (2) from the compressor.
  6. Remove the old O-ring seal from the A/C high pressure switch cavity using the J 9553-01 .
  7. Inspect the A/C high pressure switch cavity and the O-ring groove in the rear head for dirt or foreign material. Clean the components as necessary.

Installation Procedure


    Object Number: 573960  Size: SH

    Important: If you reinstall an existing control switch in the compressor, use a new O-ring and a new retainer ring. An O-ring and a retainer ring is included in a new switch kit.

  1. Lubricate the new O-ring using new 525 viscosity refrigerant oil.
  2. Install the new O-ring into the groove in the switch cavity.
  3. Lubricate the control switch housing using new 525 viscosity refrigerant oil.
  4. Install the switch (2) into the switch cavity until the switch bottoms in the cavity.
  5. Install the A/C high pressure switch snap ring using theJ 5403 . Ensure that the high point of the curved sides is adjacent to the switch housing. Ensure that the snap ring is properly seated in the switch cavity retaining groove.
  6. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  7. Leak test the fittings of the components using the J 39400-A .