GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Kodiak C-Series (Conventional) C4/C5 🢒 Driveline/Axle 🢒 Rear Drive Axle 🢒 Instrument Cluster Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Remove the instrument panel cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement.
  3. Tilt the steering column fully down, if equipped with tilt steering.

    4. Object Number: 328138 Size: SH
  4. Remove the screws (2) that retain the instrument cluster to the instrument panel carrier
  5. Remove the instrument cluster (1) from the vehicle.

Installation Procedure

    Object Number: 328138 Size: SH
  1. Position the instrument cluster (1) to the vehicle.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the screws (2) that retain the instrument cluster to the instrument panel carrier.

    3. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  3. Install the instrument panel cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement.
  4. Tilt the steering column to the up position, if equipped with tilt steering.
  5. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
  6. Refer to Control Module References for programming and setup information.