GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Kodiak C-Series (Conventional) C4/C5 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Drive Belt Replacement

Removal Procedure

    Object Number: 1363113 Size: SH
  1. Install a 1/2 inch breaker bar into the tensioner opening and rotate the tensioner counterclockwise.
  2. Remove the belt from the tensioner.
  3. Slowly release the tension on the tensioner arm.
  4. Remove the drive belt from the drive pulleys , if equipped with a single generator.

    5. Object Number: 1363115 Size: SH
  5. Remove the drive belt from the drive pulleys, if equipped with dual generators.
  6. Inspect the drive belt for excessive cracking or any visible damage and replace if necessary.

Installation Procedure

    Object Number: 1363115 Size: SH
  1. Install a 1/2 inch breaker bar into the tensioner opening and rotate the tensioner counterclockwise.
  2. Install the drive belt, if equipped with dual generators.
  3. Route the drive belt over and/or around all the drive pulleys except for the tensioner.

    4. Object Number: 1363113 Size: SH
  4. Install the drive belt, if equipped with a single generator.
  5. Route the drive belt over and/or around all the drive pulleys except for the tensioner.
  6. Install the belt over and/or around the tensioner.
  7. Slowly release the tension on the tensioner arm.
  8. Inspect the drive belt for proper installation on and/or around all pulleys.