Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step tests if ground is constantly being applied to the horn relay.
-
The horn relay control circuit includes the horn switch. The horn switch must be tested for a short to ground when testing the relay control circuit.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Horn Schematics Connector End View: Horn Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Depress and release the horn switch. Are the horns ON at all times? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections |
3 | Disconnect the horn relay. Are the horns ON at all times? | Go to Step 7 | Go to Step 4 |
Connect a test lamp between the battery positive voltage circuit of the horn relay coil and the horn relay control circuit. Does the test lamp illuminate? | Go to Step 6 | Go to Step 5 | |
5 | Inspect for poor connections at the horn relay. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 9 | Go to Step 8 |
Repair the short to ground in the horn relay control circuit. Refer to Circuit Testing and Wiring Repairs . Did you complete the repair? | Go to Step 9 | -- | |
7 | Repair the short to battery positive in the horn control circuit. Refer to Circuit Testing and Wiring Repairs . Did you complete the repair? | Go to Step 9 | -- |
8 | Replace the horn relay. Refer to Relay Replacement . Did you complete the replacement? | Go to Step 9 | -- |
9 | Operate the horns. Do the horns operate properly? | System OK | Go to Step 1 |
