Tools Required

J 42640 Steering Column Pin

1. Install the J 42640 in the steering column lower access hole.
2. Remove the intermediate shaft from the steering gear. Refer to Intermediate Steering Shaft Replacement .



3. Remove the bolts retaining the lower steering column seal (1).
4. Remove the lower steering column seal from the vehicle.



5. Remove the upper steering column seal from the steering column.

1. Install the upper steering column seal to the steering column.
2. Install the lower steering column seal to the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




3. Install the bolts retaining the lower steering column seal (1).

Tighten
Tighten the retaining bolts to 2 N·m (18 lb in).

4. Install the intermediate shaft to the steering gear. Refer to Intermediate Steering Shaft Replacement .



5. Remove the J 42640 from the steering column lower access hole.