GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution: Hot engine coolant may cause severe burns. Although the cooling system has been drained, coolant still remains in the engine water jacket. This coolant will drain with the removal of the knock sensor.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

  2. Object Number: 892627  Size: SH
  3. Drain the cooling system. Refer to Cooling System Draining and Filling in Engine Cooling.
  4. Disconnect the knock sensor electrical connector (2).
  5. Remove the knock sensor (1).

Installation Procedure

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

    Important: DO NOT apply thread sealant to sensor threads. The sensor is coated at factory and applying additional sealant will affect the sensors ability to detect detonation.

  1. Install the knock sensor (1).
  2. Tighten
    Tighten the knock sensor to 19 N·m (14 lb ft).


    Object Number: 892627  Size: SH
  3. Connect the knock sensor electrical connector (2).
  4. Lower the vehicle.
  5. Fill the cooling system. Refer to Cooling System Draining and Filling in Engine Cooling.