Front Fog Lamp Replacement Impala

1. Remove the screw from the fog lamp.
2. Remove the fog lamp from the front bumper fascia.



3. Disconnect the electrical connector from the fog lamp bulb.
4. Remove the fog lamp bulb, turning counterclockwise.

1. Install the fog lamp bulb, turning clockwise.
2. Connect the electrical connector to the fog lamp.
3. Install the fog lamp to the front bumper fascia.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




4. Install the screw to the fog lamp.

Tighten
Tighten the screws to 5 N·m (44 lb in).

Front Fog Lamp Replacement Monte Carlo

1. Remove the headlamp. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement .
2. Disconnect the electrical connector from the fog lamp.
3. Remove the bulb from the socket, turning counterclockwise.
4. Remove the push-on clips using a small flat bladed tool.



5. Remove the screw from the fog lamp.
6. Remove the fog lamp from the front bumper fascia.

1. Install the fog lamp to the front bumper fascia location tabs.
2. Install the push-on clips to the front bumper fascia location tabs, pressing on until fully seated.
3. Install the bulb to the socket, turning clockwise.
4. Connect the electrical connector from the fog lamp.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the screw to the fog lamp.

Tighten
Tighten the screw to 5 N·m (44 lb in).

6. Install the headlamp. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement .