GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Important: The ignition switch must be in the OFF position when removing the instrument cluster.


    Object Number: 519478  Size: SH
  1. Remove the instrument panel (I/P) cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  2. Remove the instrument cluster screws.
  3. Pull the instrument cluster towards you and disconnect the electrical connector.
  4. Remove the instrument cluster from the I/P.

Installation Procedure


    Object Number: 519478  Size: SH
  1. Connect the electrical connector to the instrument cluster.
  2. Install the instrument cluster to the I/P.
  3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the instrument cluster screws.
  5. Tighten
    Tighten the instrument cluster screws to 2 N·m (18 lb in).

  6. Install the I/P cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement.
  7. If a new instrument cluster was installed, refer to the IPC Setup in the scan tool Special Functions menu.
  8. Refer to Control Module References for programming and setup information.