Schematic Reference: Instrument Cluster Schematics

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Install a scan tool.
2. Raise the vehicle's drive wheels. Refer to Lifting and Jacking the Vehicle in General Information.
3. Start the engine.
4. Place the transmission into drive.
5. With the scan tool, observe the Vehicle Speed Sensor parameter in the powertrain control module (PCM) Engine Data 1 data list.

Does the Vehicle Speed Sensor parameter match the speedometer display?

Go to Step 3

Go to Step 4

Does the odometer operate properly?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 4

Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 5

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2