GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical-3.8L.

  2. Object Number: 155466  Size: SH
  3. Disconnect the idle air control valve (IAC) electrical connector.

  4. Object Number: 185614  Size: SH
  5. Remove the IAC valve screws.

  6. Object Number: 185583  Size: SH
  7. Remove the IAC valve.

  8. Object Number: 185626  Size: SH
  9. Remove the IAC valve O-ring.

Installation Procedure

Notice: The IAC valve may be damaged if installed with the cone (pintle) extended more than 28 mm (1-1/8 in). Measure the distance that the valve is extended before installing a new valve. The distance from the idle air control valve motor housing to the end of the idle air control valve pintle should be less than 28 mm (1-1/8 in). Manually compress the pintle until the extension is less than 28 mm (1-1/8 in).


    Object Number: 185626  Size: SH
  1. Install the new IAC valve O-ring .

  2. Object Number: 185583  Size: SH
  3. Install the IAC valve in the throttle body.

  4. Object Number: 185614  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the IAC valve screws.
  6. Tighten
    Tighten the screws to 3 N·m (27 lb in).


    Object Number: 155466  Size: SH
  7. Connect the IAC valve electrical connector.
  8. The powertrain control module (PCM) will reset the IAC valve whenever the ignition is turned ON, then OFF. Turn ON the ignition for 10 seconds, then OFF for 5 seconds.
  9. Start the engine and allow the engine to reach operating temperature.
  10. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical-3.8L.