GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 601131  Size: SH
  1. Apply the parking brake.
  2. If the vehicle is equipped with a column shift, position the transaxle shift control indicator to 1.
  3. Adjust the steering wheel for access.
  4. Using a small, flat-bladed tool, gently remove the bezel from the ignition lock cylinder.

  5. Object Number: 813479  Size: SH
  6. For the Impala, remove the right and the left access covers from the instrument panel (IP) fuse block.
  7. For the Monte Carlo, remove the left access cover from the IP fuse block.

  8. Remove the steering column filler. Refer to Steering Column Opening Filler Replacement .
  9. For the Monte Carlo, open the instrument panel compartment door.
  10. Remove the trim plate screws from the IP cluster.
  11. Start at the left side of the IP cluster trim plate. Grasp the trim plate and carefully pull rearward. Disengage the IP cluster trim plate in order to easily access the hazard warning switch.

  12. Object Number: 519460  Size: SH
  13. Disconnect the electrical connectors from the hazard warning switch.
  14. Remove the hazard warning switch from the IP cluster trim plate.

Installation Procedure


    Object Number: 519460  Size: SH
  1. Install the hazard warning switch to the IP cluster trim plate.
  2. Connect the electrical connector to the hazard warning switch.

  3. Object Number: 813479  Size: SH
  4. Press the IP cluster trim plate into the IP trim pad, until all of the retainers are fully seated.
  5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Install the IP cluster trim plate screws.
  7. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  8. For the Monte Carlo, install the left access cover to the IP fuse block.
  9. For the Impala, install the right and the left access covers to the IP fuse block.

  10. Install the steering column filler. Refer to Steering Column Opening Filler Replacement .
  11. For the Monte Carlo, close the IP compartment door.

  12. Object Number: 601131  Size: SH
  13. Install the bezel to the ignition lock cylinder.
  14. Reposition the steering wheel to the original position.
  15. If the vehicle is equipped with column shift, position the transaxle shift control indicator to Park.
  16. Release the parking brake.