GM Service Manual Online
For 1990-2009 cars only

Circuit Description

Output driver modules (ODM) are chips that are inside the powertrain control module (PCM). ODMs provide grounded outputs that control devices. Each output has an internal feedback circuit that connects to the PCM microprocessor. ODM 4 determines if the voltage or the current may cause damage to the PCM. The PCM monitors voltage through the ignition 1 input. Any incorrect current that is on a circuit to the ODM will cause the ODM to report this diagnostic trouble code (DTC).

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

    • The ODM has detected a voltage greater than 33 volts.
        OR
    • Excessive current is detected on any circuit to the ODM.
    • The condition is present for 30 seconds.

Action Taken When the DTC Sets

    • The control module stores the DTC information into memory when the diagnostic runs and fails.
    • The malfunction indicator lamp (MIL) will not illuminate.
    • The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records.
    • The driver information center, if equipped, may display a message.

Conditions for Clearing the DTC

    • A current DTC Last Test Failed clears when the diagnostic runs and passes.
    • A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
    • Clear the DTC with a scan tool.

Diagnostic Aids

An over charging condition may set this DTC. Refer to Diagnostic System Check - Engine Electrical in Engine Electrical.

Thoroughly inspect any circuitry that is suspected of causing the intermittent complaint. Repair the circuits as necessary. Refer to Intermittent Conditions .

Step

Action

Yes

No

Schematic Reference: Engine Controls Schematics

1

Did you perform the Diagnostic System Check-Engine Controls?

Go to Step 2

Go to Diagnostic System Check - Engine Controls

2

Is DTC P0560 set?

Go to Diagnostic System Check - Engine Electrical in Engine Electrical

Go to Step 3

3

  1. With a scan tool, select the Output Driver Data list.
  2. Observe the parameters on the scan tool.

Do any parameters indicate a fault present?

Go to Step 4

Go to Step 5

4

Test for a short to voltage on the circuit to the component that indicated a fault.

Did you find and correct the condition?

Go to Step 6

Go to Step 5

5

Replace the PCM. Refer to Powertrain Control Module Replacement .

Did you complete the replacement?

Go to Step 6

--

6

  1. Use the scan tool in order to clear the DTCs.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC run and pass?

Go to Step 7

Go to Step 2

7

With a scan tool, observe the stored information, Capture Info.

Does the scan tool display any DTCs that you have not diagnosed?

Go to Diagnostic Trouble Code (DTC) List

System OK