Test Description
The number(s) below refer to the step number(s) on the diagnostic table.
-
Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
-
The symptom list in Symptoms will determine the correct diagnostic procedure to use.
-
The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
Step | Action | Yes | No | ||||
|---|---|---|---|---|---|---|---|
1 | Install a scan tool. Does the scan tool power up? | Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications | ||||
Attempt to establish communication with the following:
Does the scan tool communicate with the Radio and Remote CD Changer? | Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |||||
Select the following display DTC functions on the scan tool:
Does the scan tool display any DTCs? | Go to Step 4 | Go to Symptoms | |||||
Does the scan tool display any DTCs which begin with a "U"? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 5 | |||||
5 | Does the scan tool display DTC B1000 or B1004? | Go to Diagnostic Trouble Code (DTC) List/Type in Body Control System | Go to Step 6 | ||||
6 | Does the scan tool display DTC B1327? | Go to Diagnostic Trouble Code (DTC) List/Type in Engine Electrical |
