The MAF sensor on this engine is attached to the throttle body assembly.

1. Turn OFF the ignition.
2. Remove the Injector Sight Shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.
3. Disconnect the MAF sensor electrical connector.



4. Remove the screws holding MAF sensor to throttle body.
5. Remove the MAF sensor from the throttle body.

1. Carefully position the MAF sensor to the throttle body.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the screws holding the MAF sensor to the throttle body.

Tighten
Tighten the screws to 3N·m (27 lb in).

3. Connect the electrical connector.
4. Install the Injector Sight Shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.