GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 HHR 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Transmission Fluid Pressure Manual Valve Position Switch Replacement

Removal Procedure

    Object Number: 1205810 Size: SH
  1. Remove the transmission side cover. Refer to Control Valve Body Cover Replacement.
  2. Remove the six bolts from the transmission fluid pressure (TFP) switch assembly.
  3. Remove the TFP switch assembly from the control valve body assembly (18). The 4 pressure switch O-rings are reusable and should remain with the TFP switch assembly.

Installation Procedure

    Object Number: 1205810 Size: SH
  1. Install the TFP switch assembly to the control valve body assembly (18). The 4 pressure switch O-rings are reusable and should remain with the TFP switch assembly.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the six bolts to the TFP switch assembly and tighten to 12 N·m (9 lb ft).
  3. Install the transmission side cover. Refer to Control Valve Body Cover Replacement.

    4. Note: It is recommended that transmission adaptive pressure (TAP) information be reset.

    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.

  4. Reset the TAP values. Refer to Transmission Adaptive Functions.