GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The engine control module (ECM)/powertrain control module (PCM) monitors the system voltage to make sure that the voltage stays within the proper range. If the ECM/PCM detects an excessively low system voltage, DTC P0562 will set.

When the charging system detects a fault, the instrument panel cluster (IPC) displays a message or the charge indicator will light.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC P0562 System Voltage Low

Conditions for Running the DTC

    • The engine run time is more than 20 seconds and above 1,200 RPM.
    • The vehicle speed is above 8 km/h (5 mph).

Conditions for Setting the DTC

The ECM/PCM detects an improper voltage below 11 volts for 5 seconds.

Action Taken When the DTC Sets

    • The ECM/PCM stores the DTC information into memory when the diagnostic runs and fails.
    • The ECM/PCM will store conditions which were present when the DTC set as Failure Records data only.
    • The ECM/PCM disables most outputs.
    • The transmission defaults to a predetermined gear.
    • The torque converter clutch (TCC) operation is inhibited.
    • The IPC displays a message.
    • The malfunction indicator lamp (MIL) will not illuminate.

Conditions for Clearing the DTC

    • The Conditions for Setting the DTC are no longer present.
    • A history DTC will clear after 40 malfunction-free ignition cycles.

Step

Action

Value(s)

Yes

No

Schematic Reference: Starting and Charging Schematics

Connector End View Reference: Engine Electrical Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

--

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

With the scan tool monitor the ignition 1 signal voltage in the engine control module (ECM)/powertrain control module (PCM) data list.

Does the scan tool display ignition 1 voltage greater than the specified value?

11 V

Go to Step 4

Go to Step 3

3

Test the ignition feed circuit to the ECM/PCM for high resistance or open. Refer to Circuit Testing and Wiring Repairs.

Did you find and correct the condition?

--

Go to Step 7

Go to Step 5

4

  1. Inspect for poor connections at the ECM/ PCM. Refer to Testing for Intermittent Conditions and Poor Connections.
  2. If you find a poor connection, repair the condition as necessary. Refer to Wiring Repairs.

Did you find and correct the condition?

--

Go to Step 7

Go to Step 6

5

Repair the ignition feed circuit to the ECM/PCM for an open or a short to ground. Refer to Wiring Repairs.

Is the action complete?

--

Go to Step 7

--

6

Replace the ECM/ PCM. Refer to Control Module References for replacement, setup, and programming.

Is the action complete?

--

Go to Step 7

--

7

  1. Select the Diagnostic Trouble Code (DTC) option and the Clear DTC Information option using the scan tool.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text, if applicable.

Does the DTC reset?

--

Go to Step 2

System OK