GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Express - AWD 🢒 Seats 🢒 Seat Hardware, Trim, and Upholstery 🢒 Driver or Passenger Seat Replacement

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

  1. Disable the SIR. Refer to SIR Disabling and Enabling .
  2. If seat is equipped with power seat motors, disconnect the electrical connector from the seat assembly.

    3. Object Number: 333620 Size: SH
  3. Remove the nuts (3) that retain the seat assembly to the vehicle.
  4. Remove the front seat assembly from the vehicle.

Installation Procedure

    Object Number: 333620 Size: SH
  1. Position the front seat assembly into the vehicle.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the nuts  (3).

    3. Tighten
    Tighten the nuts to 60 N·m (44 lb ft).

  3. Connect the electrical connector to the seat assembly, if equipped with power seat motors.
  4. Enable the SIR. Refer to SIR Disabling and Enabling .