GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the engine cover. Refer to Engine Cover Replacement .
  2. Remove the exhaust gas recirculation (EGR) cooler tube. Refer to Exhaust Gas Recirculation Valve Cooler Replacement .

  3. Object Number: 1732190  Size: SH
  4. Disconnect the fuel rail pressure sensor electrical connector (1).
  5. Prior to removal, clean the fuel pressure sensor and surrounding area thoroughly with solvent, such as GM P/N 12377981 (Canadian P/N 10953463) or equivalent.
  6. Using compressed air, thoroughly blow dry the sensor and surrounding area.
  7. Remove the fuel pressure sensor (3).

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1732190  Size: SH
  1. Install the fuel pressure sensor (3).
  2. Tighten
    Tighten the sensor to 70 N·m (52 lb ft).

  3. Connect the fuel rail pressure sensor electrical connector (1).
  4. Install the EGR cooler tube. Refer to Exhaust Gas Recirculation Valve Cooler Replacement .
  5. Prime the fuel system. Refer to Fuel System Priming .
  6. Start the engine. If the engine stalls, repeat the above step.
  7. Once the engine starts, inspect for fuel leaks.
  8. Install the engine cover. Refer to Engine Cover Replacement .