Important: Perform the CKP system variation learn procedure whenever the crankshaft position (CKP) sensor is removed or replaced. Refer to Crankshaft Position System Variation Learn .

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .



2. Disconnect the CKP sensor harness connector.



3. Remove the CKP sensor mounting bolt.



4. Remove the CKP sensor.

Important: When installing the CKP sensor, make sure the sensor is fully seated before tightening the mounting bolt. A poorly seated CKP sensor may perform erratically and may set false DTCs.

Important: Do not use the original O-ring.

1. Replace the CKP sensor O-ring.
2. Lubricate the O-ring with clean engine oil before installing the CKP sensor.




Important: Make sure the CKP sensor mounting surface is clean and free of burrs.

3. Install the CKP sensor.

Notice: Refer to Fastener Notice in the Preface section.




4. Install the CKP sensor mounting bolt.

Tighten
Tighten the mounting bolt to 8 N·m (71 lb in).




5. Connect the CKP sensor harness connector.
6. Lower the vehicle.
7. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .