GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the spark plug wires. Refer to Spark Plug Wire Replacement .

  2. Object Number: 14824  Size: SH
  3. Loosen each spark plug 1 or 2 turns.
  4. Brush or air blast away any dirt from around the spark plugs.
  5. Remove the spark plugs 1 at a time. Place each plug in a tray marked with the corresponding cylinder numbers.

Installation Procedure


    Object Number: 14824  Size: SH
  1. Properly position each spark plug washer.
  2. Inspect each spark plug gap. Adjust each plug as needed.
  3. Specification
    Spark plug gap: 1.524 mm (0.060 in)

  4. Hand start the spark plugs in the corresponding cylinders.
  5. Notice: Refer to Fastener Notice in the Preface section.

  6. Tighten the spark plugs.
  7. Tighten

        • For used heads tighten the spark plugs to 15 N·m (11 lb ft).
        • For new aluminum heads tighten the spark plugs to 20 N·m (15 lb ft).
        • For new iron heads, tighten the spark plugs to 30 N·m (22 lb ft).
  8. Install the spark plug wires. Refer to Spark Plug Wire Replacement .