Tools Required

1. Using a brass drift, install the input shaft bearing in the clutch housing.



2. Using the J 36798  (2) with the bushing side against the bushing and the J 36190  (1), install the shift shaft bushing in the clutch housing.



3. Using the J 36798 with the staking side against the bushing and the J 36190 , stake the bushing in place.



4. Using the J 36507  (2) and the J 36190  (1), install the inner shift shaft detent bushing to the second mark on the J 36507 .



5. Using the J 36507  (2) and the J 36190  (1), install the outer shift shaft detent bushing to the first mark on the J 36507 .



6. Install the transmission vent.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

7. Using the J 36511 install the oil fill plug.

Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the drain plug threads.

Tighten
Tighten the fill plug to 30 N·m (22 lb ft).




8. Using the J 36511 , install the oil drain plug.

Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the drain plug threads.

Tighten
Tighten the drain plug to 30 N·m (22 lb ft).




9. Using the J 25070 , heat the clutch housing front countershaft bearing bore for ten minutes.



10. Using a suitable bearing installing tool, install the front countershaft bearing in the clutch housing.