GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The instrument panel cluster (IPC) illuminates the ABS indicator by supplying ground to the lamp. The electronic brake control module (EBCM) sends serial data messages to the IPC to command the indicator ON or OFF.

Diagnostic Aids

The malfunction must be present during diagnosis in order to prevent unnecessary parts replacement. Always begin diagnosis with Diagnostic System Check - Vehicle in Vehicle DTC Information.

Test Description

The number below refers to the step number on the diagnostic table.

  1. This step tests if the IPC is able to turn OFF the ABS indicator.

Step

Action

Yes

No

Important: An ECE 13 response may cause the ABS indicator to remain ON when no DTCs are set. It is necessary to verify that ECE 13 is not causing the ABS indicator to remain illuminated, prior to performing this diagnostic. Refer to ABS Description and Operation for a complete description of the ECE 13 response.

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the ABS indicator.

Does the ABS indicator illuminate for approximately 2 seconds and then turn OFF?

Go to Diagnostic Aids

Go to Step 3

3

  1. Select the Instrument Panel Cluster Special Functions menu on the scan tool.
  2. Select Lamp Tests.
  3. Command the instrument panel cluster (IPC) indicator lamps OFF.

Does the ABS indicator turn OFF?

Go to Step 5

Go to Step 4

4

Replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console.

Did you complete the replacement?

Go to Step 6

--

5

Important: Following electronic brake control module (EBCM) replacement, perform the set-up procedure for the EBCM and use the scan tool to perform the Tire Size Calibration procedure.

Replace the EBCM. Refer to Electronic Brake Control Module Replacement .

Did you complete the replacement?

Go to Step 6

--

6

  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the ABS indicator.

Does the ABS indicator illuminate for approximately 2 seconds and then turn OFF?

System OK

Go to Step 3