Tools Required

1. Remove the turbine shaft front oil seal ring (2).



2. Using the J 23129 and the J 6125-1B , remove the torque converter oil seal assembly (201).



3. Remove the seven oil pump bolt and seal assemblies (3).

Important: Install the J 37789-A so the bottom clamp portion of the tool is located under the oil pump shaft splines.

4. Attach the J 37789-A to the oil pump shaft. Tighten the thumb screw.
5. Turn the handle of the J 37789-A down onto the turbine shaft in order to raise the oil pump assembly (4) out of the case.
6. Remove the oil pump assembly (4).
7. Remove the J 37789-A .



8. Remove the transmission oil pump gasket (6).

Important: The selective thrust washer (218) may be stuck to the pump cover.

9. Remove the selective thrust washer (218).