GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 39400-A Halogen Leak Detector

Removal Procedure


    Object Number: 297225  Size: SH
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  2. For compression-style fittings; use a back-up wrench on the A/C refrigerant component (smaller size) fitting (2), then loosen the A/C refrigerant hose (larger size) fitting (1).
  3. For banjo-style fittings; remove the bolt retaining the A/C refrigerant hose to the A/C refrigerant component.
  4. Important: Cap or tape the open A/C refrigerant hose and the A/C refrigerant component immediately.

  5. Disconnect the A/C refrigerant hose from the A/C refrigerant component, discard the O-ring seal and cap or tape the A/C refrigerant hose and the A/C refrigerant component to prevent contamination.

Installation Procedure


    Object Number: 297232  Size: SH
  1. Remove the cap or tape from the A/C refrigerant hose and the A/C refrigerant component.
  2. Using a lint-free clean, dry cloth, carefully clean the sealing surfaces of the A/C refrigerant hose and the A/C refrigerant component.
  3. Lightly coat the new O-ring seal (1) with mineral base 525 viscosity refrigerant oil.
  4. Important: DO NOT allow any of the mineral base 525 viscosity refrigerant oil on the new O-ring seal to enter the refrigerant system.

  5. For compression-style fittings; carefully slide the new O-ring seal (1) onto the A/C refrigerant hose until seated.

  6. Object Number: 297228  Size: SH
  7. For banjo-style fittings; carefully slide the new O-ring seal (1) onto the A/C refrigerant hose until seated.
  8. Leave a light coating of the refrigerant oil to remain on the A/C refrigerant hose in the area indicated (2) ONLY.


    Object Number: 297225  Size: SH
  9. Install the A/C refrigerant hose to the A/C refrigerant component.
  10. For compression-style fittings; use a back-up wrench on the A/C refrigerant component (smaller size) fitting (2), then tighten the A/C refrigerant hose (larger size) fitting (1) to specification.
  11. For banjo-style fittings; install the bolt retaining the A/C refrigerant hose to the A/C refrigerant component, then tighten to specification.
  12. Evacuate and charge the refrigerant system. Refer to Refrigerant Recovery and Recharging .
  13. Leak test the fitting(s) of the repaired or reinstalled component using the J 39400-A .