GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Important: Perform the CKP system variation learn procedure whenever the crankshaft position (CKP) sensor is removed or replaced. Refer to Crankshaft Position System Variation Learn .

  1. Raise the vehicle.

  2. Object Number: 325346  Size: SH
  3. If the vehicle is equipped with the underbody shield package, remove the mounting bolts for the steering linkage shield .

  4. Object Number: 325348  Size: SH
  5. Remove the steering linkage shield.

  6. Object Number: 10937  Size: SH
  7. Disconnect the CKP sensor harness connector.

  8. Object Number: 10938  Size: SH
  9. Remove the CKP sensor mounting bolt.

  10. Object Number: 11485  Size: SH
  11. Remove the CKP sensor.

Installation Procedure

Important: When installing the CKP sensor, make sure the sensor is fully seated before tightening the mounting bolt. A poorly seated CKP sensor may perform erratically and may set false DTCs.

    Important: Do not use the original O-ring.

  1. Replace the CKP sensor O-ring.
  2. Lubricate the O-ring with clean engine oil before installing the CKP sensor.

  3. Object Number: 11485  Size: SH

    Important: Make sure the CKP sensor mounting surface is clean and free of burrs.

  4. Install the CKP sensor.

  5. Object Number: 10938  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Install the CKP sensor mounting bolt.
  7. Tighten
    Tighten the mounting bolt to 8 N·m (71 lb in).


    Object Number: 10937  Size: SH
  8. Connect the CKP sensor harness connector.

  9. Object Number: 325348  Size: SH
  10. Install the steering linkage shield.

  11. Object Number: 325346  Size: SH
  12. Install the mounting bolts for the steering linkage shield.
  13. Tighten
    Tighten the bolts to 33 N·m (24 lb ft).

  14. Lower the vehicle.
  15. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .