Preliminary Procedures

1. Place the ignition switch in the OFF position.
2. Remove the underhood electrical center bracket. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .

1

Brake Modulator Assembly Bracket Bolt

Notice: Refer to Fastener Notice in the Preface section.

Tighten
20 N·m (15 lb ft)

2

Brake Modulator Assembly Bracket Nut (Qty: 2)

Tighten
10 N·m (89 lb in)

3

Brake Modulator Assembly Bracket

Tip
Without disconnecting the brake pipe fittings, carefully remove and support the brake modulator assembly.