GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Equinox 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

Removal Procedure

    Object Number: 1836024 Size: SH
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement.
  2. Disconnect the engine wiring harness electrical connector (6) from the bank 2 exhaust camshaft position (CMP) sensor.

    3. Object Number: 1285243 Size: SH
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.

Installation Procedure

    Object Number: 1285243 Size: SH
  1. Install the CMP sensor.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the CMP sensor bolt.

    3. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1836024 Size: SH
  3. Connect the engine wiring harness electrical connector (6) to the bank 2 exhaust CMP sensor.
  4. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement.