Callout
| Component Name
|
|
Notice: Refer to Fastener Notice in the Preface section. Fastener Tightening Specifications:
Refer to
Fastener Tightening Specifications .
|
1
| Windshield Washer Arm Nut (Qty: 4)
Tighten
28 N·m (21 lb ft) |
2
| Windshield Washer Arm Assembly
Tip
| • | Position wiper blade assembly at the dot in lower portion of windshield blackout strip on driver side of vehicle. |
| • | Position wiper blade assembly at the dot in windshield pillar portion of windshield blackout strip on passenger side of vehicle. |
|
3
| Windshield Washer Module Bolt (Qty: 4)
Tip
Remove the air inlet grille panel to access the wiper motor module. Refer to
Air Inlet Grille Panel Replacement.
Tighten
12 N·m (9 lb ft) |
4
| Windshield Washer Module Assembly
Tip
- Disconnect the electrical connector.
- After installation turn the key to RUN position and cycle wiper system to ensure motor is in the park position before installing the wiper arms.
|
