GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Equinox 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Instrument Panel Electrical Center or Junction Block Replacement

Removal Procedure

    Important: Record all preset radio stations.

  1. Turn the ignition OFF.
  2. Remove the screws from the battery cooling box. Remove the battery cover.
  3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  4. Disconnect the positive battery cable.
  5. Remove the console. Refer to Console Replacement .

    6. Object Number: 1232488 Size: SH
  6. Remove the nut holding the following fuse block connectors to the back of the I/P fuse block (4):
    7. • The body connector (1)
    • The I/P connector (2)
    • The I/P connector (3)

    Object Number: 934747 Size: SH
  7. Remove the bolt holding the fuse block into place.
  8. Remove the ground wire (1).
  9. Remove the fuse block.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 934747 Size: SH
  1. Install the fuse block and attach the ground wire (1) and attach the bolt.

    2. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1232488 Size: SH
  2. Connect the harness connectors to the back of the I/P fuse block (4).

    3. Tighten
    Tighten the connectors to 4 N·m (35 lb in).

  3. Install the console. Refer to Console Replacement .
  4. Connect the positive battery cable.

    5. Tighten
    Tighten the bolt to 17 N·m (13 lb ft).

  5. Connect the negative battery cable.

    6. Tighten
    Tighten the bolt to 17 N·m (13 lb ft).

  6. Install the battery cooling box cover and install the screws.

    7. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  7. Set the radio stations to the preset selections.