Each of the following service procedures may require programming or setup procedures to be performed on the HVAC control module or HVAC actuators.

If the HVAC control module is replaced, the following procedure must be performed:

Reprogram HVAC control module--Refer to Service Programming System (SPS) .

The control knobs must also be turned from end point to end point to calibrate the potentiometers.

Do not reprogram the HVAC control module unless directed by a service procedure or a service bulletin.

Reprogram HVAC Control Module--Refer to Service Programming System (SPS) .

If an actuator is replaced, the following procedure must be performed:

Re-Calibrating Actuators--Refer to Actuator Recalibration for the manual system