Front Bumper Fascia Replacement Equinox

1. Remove the fascia to tie bar push-in retainers (1).
2. Remove the fascia to fender screw from inside the wheelhouse.



3. Remove the fascia to wheelhouse liner push-in retainers (1).



4. Remove the fascia to vehicle push-in retainers (3, 5).



5. Gently pull the fascia away from the vehicle, near the headlamps, to disengage the radiator grille strap to headlamp retainer.



6. Pull the fascia away from the vehicle, by the fender, to disengage.
7. Slide the fascia forward off the vehicle.
8. Disconnect the fog lamp from the fog lamp housing, if equipped.

1. Position the front fascia assembly (3) to the vehicle.
2. Connect the fog lamp to the fog lamp housing, if equipped.



3. Push the fascia in at the fender to secure.
4. Secure the radiator grille strap retainer to the headlamp by pushing inward until secure.



5. Install the fascia to vehicle push-in retainers (3, 5).



6. Install the fascia to the wheelhouse liner push-in retainers (1).

Notice: Refer to Fastener Notice in the Preface section.

7. Install the fascia to fender screw from inside the wheelhouse.

Tighten
Tighten the screw to 2 N·m (18 lb in).




8. Install the fascia to the tie bar push-in retainers (1).

Front Bumper Fascia Replacement Torrent