For 1990-2009 cars only
Removal Procedure
- Place the front wheels in the straight forward position with the steering wheel centered.
- Disable the SIR system. Refer to SIR Disabling and Enabling .
- Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
- Remove the steering wheel. Refer to Steering Wheel Replacement in Steering Wheel and Column.
- Remove the steering column covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
- Release the SIR coil harness clips from the bracket below the column.
- Disconnect both the SIR coil and horn/cruise connectors.
- Using a small flat-bladed tool, carefully pry the retaining tabs away from the SIR coil assembly and slide the SIR coil assembly off the steering column.
Notice: The new SIR coil assembly will be centered. Improper alignment of the SIR coil assembly may damage the unit, causing an inflatable restraint malfunction.
Installation Procedure
- Route the SIR wiring harness and horn/cruise connector down steering column.
- Snap the SIR coil into position on the column.
- Connect the SIR coil and horn/cruise electrical connectors.
- Attach the wiring harness clips to the bracket below the column.
- Install the steering column covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
- Install the steering wheel. Refer to Steering Wheel Replacement in Steering Wheel and Column.
- Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
- Enable the SIR system. Refer to SIR Disabling and Enabling .
Important: A new roll connector is equipped with a yellow tab that is removed after the steering wheel is installed. This tab passes through the steering wheel.
