For 1990-2009 cars only
Removal Procedure
- Disconnect the electrical connectors from the stop lamp switch.
- Rotate the stop lamp switch counterclockwise and remove the switch from the switch retainer.
- Gently compress the locking tabs on the switch retainer and remove the switch retainer from the brake pedal assembly.
Important: Depressing the brake pedal will allow easier access to the locking tabs on the stop lamp retainer.
Installation Procedure
- Connect the electrical connectors on the stop lamp switch.
- Install the switch to the bracket by turning and pushing the switch until the switch bottoms on the brake pedal.
- Inspect the stop lamps for proper operation
Notice: Proper stoplamp switch adjustment is essential. Improper stoplamp switch adjustment may cause brake drag, heat buildup and excessive brake lining wear.
Important: Do NOT depress the brake pedal assembly during the stop lamp switch installation. This will cause a drag condition on the brake.
Important: Inspect the retainer to insure that the locking tabs have locked into position and the retainer is in place.
